Note: Free Mobile Recovery for Android (a free version of G2tool Mobile Recovery for Android) can not be registered. Please register the full version – G2tool Mobile Recovery for Android with the code you’ve purchased. You can download full version of G2tool Mobile Recovery for Android from your email when you’ve purchased.
Stop use your Android device after you lost data from it. Any new data written into the device may overwrite the lost data and make it unrecoverable.
1. Install and launch G2tool Mobile Recovery for Android.
Double click the installation package to install G2tool Mobile Recovery for Android on your computer. After that, click the app icon to run it.(g2tool mobile recovery for android)
2. Connect Your Android Device to Computer.
Run this G2tool Mobile Recovery for Android software, you will get the interface as below. Please use a USB cable to connect Android device to the computer.
Tip: You’d better connect one Android device at a time, and don’t disconnect it in the process of recovery.
3. Enable USB Debugging on Android (Optional).
Identify your android device. Please wait a moment.
If you didn’t enable USB debugging on your device, you will see the interface below. Follow the detailed guide in the window to set it now.
For Android 2.3 or earlier: Navigate to “Settings” > Click “Applications” > Click “Development” > Check “USB debugging”.
For Android 4.0 and 4.1: Navigate to “Settings” > Click “Developer options” > Check “USB debugging”.
For Android 4.2 or later: Navigate to “Settings” > Click “About Phone” > Tap “Build number” for several times until getting a pop-up note “You are under developer mode” > Back to “Settings” > Access to “Developer options” > Check “USB debugging”.
4. Analyze and Scan Data on Your Android Device.
After enabled USB debugging on your device, click “Opened? Next…”. The program will automatically identify your device. Then click “Start” to scan data on it.
Note: If the program is unable to identify your device after you enabled USB debugging, please connect your device to the computer again and check it. You’ll get a pop-up message on your device’s screen. Just click “OK” to allow USB debugging.
5 Preview and Recover Data on Your Android.
After scan, all contacts, messages, photos, videos and documents found will be listed by category. You can preview them in details. Then mark those you want and click “Recover” to save them on your computer.